Table of Contents
Advertisement
Chengdu Ebyte Electronic Technology Co,;Ltd
6.5 Configuration Mode (Mode 3)
Status
M0=1 M1=1 M2=0
Transmitting
Transmission not available, serial data received will be discarded.
Receiving
Receiving is not available.
Parameter configuration can be made in configuration mode with specific instruction format and UART 9600,
Configuring
8N1.
When entering other modes from configuration mode, the module will reconfigure parameters, AUX keeps low
Note
level during configuration;
After configuration completed, it outputs high level, so users are recommended to check the AUX rising edge.
6.6 Wake-up Mode (Mode 4)
Status
M0=0 M1=0 M2=1
Transmitting
Transmission is available.
Receiving
Receiving is not available.
Baud rate & air
Under this mode, the baud rate and air data rate are independent, both receiver and transmitter can have different
data rate
baud rate but same air data rate.
It can wake up the receiver under mode 6; wake up code will be added automatically before transmitting, the
Advantage
code number depends on the wake up time.
The transmission time is long, only applicable to wake up the receiver, not applicable for common data
Disadvantage
transmission.
Applications
For waking up the receiver under WOR mode.
Under wake up mode, the single data packet length is 84 bytes (excluding the address and channel for directional
Note
transmission).
6.7 Configuration Mode (Mode 5)
Status
M0=1 M1=0 M2=1
Transmitting
Transmission is not available. Serial data received are considered as configuration command.
Receiving
Receiving is not available.
Parameter configuration can be made in configuration mode with specific instruction format and UART 9600,
Configuration
8N1.
Chengdu Ebyte Electronic Technology Co,;Ltd
Copyright ©2012–2019，
E70-433T14S user manual
14
Advertisement
Table of Contents
