Table of Contents
Advertisement
p l a y b a c k c o n t r o l s
NOTE: In Settings, the MIDI channels are presented in
hexadecimal. If your software defines the MIDI channel in
decimal, just add 1 (so if Settings says channel "0" is selected,
that is channel "1", and so on).
After configuring the MIDI settings on the MDJ-1000V2,
start the DJ software:
• Select the MDJ-1000V2 as your MIDI device*
• Select the MDJ-1000V2 as your AUDIO device*
*Refer to DJ software's instructions
SOUN D CARD
The MDJ-1000V2 USB audio interface has the following bit
depth / sample rate options available...
•
24-bit/192kHz
•
24-bit/96 kHz
•
24-bit/48 kHz
•
16-bit/48kHz
•
16-bit/44.1 kHz
To change these settings, press the USB source select button
(26), and then open device SETTINGS (shift + BACK). Scroll
down to the SOUND CARD entry, press the browse knob to
select, turn to select one of the available options, and press
the browse knob again to activate that setting.
NOTE: Higher bit depth and sampling rates will create
greater latency and may impact performance.
m d j -
m a n u a l
g e m i n i s o u n d . c o m
1 0 0 0 V 2
•
13
Advertisement
Table of Contents
