Panasonic KX-TGD310BX Operating Instructions Manual page 48

Useful Information
Problem
I fully charged the
batteries, but
– still flashes or
– the operating time
seems to be shorter.
Making/answering calls, intercom
Problem
is displayed.
Noise is heard, sound cuts
in and out.
The handset does not ring. R The ringer volume is turned off. Adjust ringer volume (page 14,
The base unit does not
ring.
I cannot make a call.
Caller ID
Problem
Caller information is not
displayed.
48
Cause/solution
R Clean the battery ends (
a dry cloth and charge again.
R It is time to replace the batteries (page 8).
Cause/solution
R The handset is too far from the base unit. Move closer.
R The base unit's AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 33).
R Activating eco mode reduces the range of the base unit in
standby mode. If required, turn eco mode off (page 13).
R You are using the handset or base unit in an area with high
electrical interference. Re-position the base unit and use the
handset away from sources of interference.
R Move closer to the base unit.
R If you use a DSL/ADSL service, we recommend connecting a
DSL/ADSL filter between the base unit and the telephone line
jack. Contact your DSL/ADSL provider for details.
23).
R Do not disturb mode is turned on. Turn it off (page 28).
R The ringer volume is turned off. Adjust ringer volume (page 14,
23).
R The dialling mode may be set incorrectly. Change the setting
(page 13).
R You dialled a call restricted number (page 32).
R The key lock feature is turned on. Turn it off (page 16).
Cause/solution
R You must subscribe to a Caller ID service. Contact your phone
service provider for details.
R If your unit is connected to any additional telephone
equipment, remove and plug the unit directly into the wall jack.
R If you use a DSL/ADSL service, we recommend connecting a
DSL/ADSL filter between the base unit and the telephone line
jack. Contact your DSL/ADSL provider for details.
R Other telephone equipment may be interfering with this unit.
Disconnect the other equipment and try again.
, ) and the charge contacts with