Table of Contents
Advertisement
You can track the remaining time of
the delay from the delay lights. For
example: When you select the 9-hour
delay, the 6-hour light will become on
when there are 6 hours remaining until
the start of the washing programme.
To cancel the time delay function
Press and hold the Start/Pause/Cancel
key for 3 seconds. Once the cancelling
procedure has begun, your machine will
discharge for 30 seconds and the delay
function will be cancelled.
Starting the programme
To start your machine after selecting the
programme and auxiliary functions, press
Start/Pause/Cancel key.
Your machine performs water softening
depending on the hardness level of the
mains water. Due to water softening
process the programme duration may
change. The programme duration can
also change while the programme is
running depending on the ambient
temperature where your machine is
installed, temperature of the supply
water and amount of the dishes.
Pay attention not to open the door
of the machine when it is running.
Stop the machine by pressing Start/
Pause/Cancel key if you have to open
the door. Then, open the door of the
machine. There may be a rush of
vapour when you open the door of your
machine; be careful. Close the door of
your machine and press Start/Pause/
Cancel key again. Programme will
resume running.
After the rinsing step, the machine
will wait silent in pause mode for
some time in order to have the water
remaining in the machine and on the
dishes drained completely and to have
the water softener cleaned, and then it
will resume running in drying mode.
Programme follow-up
You can track the current step of the
selected programme on the programme
step lights located on the control panel.
If the drying light is on, the machine
will perform silent drying for 30-60
minutes. At the end of this period, the
Drying light will go off and the End
light will become on.The End light will
become on when the selected washing
programme ends.
Cancelling the programme
1. Press and hold the Start / Pause /
Cancel key for 3 seconds to cancel the
programme.
2. Release it when the Washing and
Drying lights start flashing. Water in
the machine will be discharged in 45
seconds. The programme will have
been cancelled once the Washing and
Drying lights go off and the End light
becomes on. Then, you can select and
operate a new programme.
There might be residues of detergent
or rinse aid left in the machine and/or
on the pieces being washed depending
on the step in which the programme
has been cancelled.
When you set the Programme
Selection Knob to "Off" position, the
washing programme will end and
the machine will be ready for a new
programme selection. If you end the
washing cycle this way, water and
detergent may remain in the machine.
33/EN
Hide quick links:
Advertisement
Table of Contents
