Safe Fleet C8Q2PD Quick Installation Manual

Drilling template
Use the following template to mark the positions of the mounting and cable entry holes on the
mounting surface.
1.8"
.81"
3.62"
2"
Support
• Phone: 1.844.899.7366
• Email: PTsupport@safefleet.net
2002/96/EC (WEEE directive): This product cannot be disposed of as unsorted
municipal waste in the European Union. For proper recycling, return the product to
your local supplier upon the purchase of equivalent new equipment, or dispose of it at
designated collection points, for more information, see www.recyclethis.info.
2006/66/EC (battery directive): This product does not contain batteries.
3.6"
2x Mounting Holes 2x 0 .27" Slots
Documentation
Additional copies of this guide, along with other supporting
documentation can be found on the Safe Fleet Community:
• https://community.safefleet.net
For use with camera model C8Q2PD03AF.
Introduction
Read these instructions before installing this
product. A qualified service person, complying
with all applicable codes, should perform the
installation.
To use this document, you must have the
following minimum qualifications:
1.81"
• Basic knowledge of electronic surveillance
systems and components
• Familiarity with electrical wiring and low
voltage electrical hookups
Kit Components
Check components for visible damage. If any
parts are damaged or missing, contact the Safe
Fleet Service team and request an RMA (Return
Material Authorization).
• Mounting bracket (MVC-9100-FF-BRKT)
• Bracket set-screw kit (020-1080)
• Qty 2 1/4" - 20 x 1/2" hex head screws
(600-1033)
• Qty 2 1/4" washers (610-1005)
Bracket adapter plate (660-1098) *
•
• Qty. 2 #8-32 x 3/8" flat head adapter plate
mounting screws (600-1030) *
• Qty. 2 #8-32 x 3/4" pan head camera
mounting screws (600-1031) *
* Shipped with C8Q2PD03AF camera
Warranty
For full warranty information, visit: www.seon.com/documents/Seon-Warranty.pdf
Service
If your bracket is to be returned for service, please call toll free 1.877.630.7366, or 1.844.899.7366,
and provide the model and/or serial# of your unit.
Ask for a Return Merchandise Authorization (RMA) number. An RMA# allows the Service
Technicians to better track your product when it comes in for service. Please show the RMA# on
the outside of the package. ANY PRODUCT SENT WITHOUT AN RMA# MAY BE REFUSED.
C8Q2PD Forward-facing Bracket
Quick Installation Guide
Installation
You can mount the bracket/camera from
above or below (inverted). Some mounting
surfaces may require reinforcement to
minimize camera vibration. In such cases,
place a tapping plate behind the mounting
surface.
Bracket Assembly and Camera
Wiring
Run the camera harness from the switch,
recorder, or PoE Injector and feed through
the cable entry hole and the mounting
bracket.
For more information, see "Mounting
the bracket assembly" in this guide, and
the C8Q2PD Quick Installation Guide
(700-1236).
© Safe Fleet | 2020 | All rights reserved | Part #: 700-1243 R1