Related Manuals for Safe Fleet PRIME DESIGN CON8505
Summary of Contents for Safe Fleet PRIME DESIGN CON8505
- Page 1 PRIME DESIGN, A SAFE FLEET BRAND ▪ Address: 1689 Oakdale Avenue #102, West St Paul, Minnesota 55118 Toll Free: 1.8.PRIME.RACK ▪ Fax: 651-552-1799 ▪ Email: info@primedesign.net ▪ Website: www.primedesign.net...
-
Page 2: Contents Overview
CONTENTS OVERVIEW CONTENTS OVERVIEW Note: This Conduit Carrier Mounting Kit is a direct fit for all Prime Design Gen 1 and 4 Ergoracks, AluRacks, and Low Profile Racks. This kit includes all new hardware, and discards all used or removed hardware if using as a replacement or for repair. - Page 3 GEN1 CONDUIT MOUNTING KIT INSTALLATION SEQUENCE NOTE: Ladder Rack and Conduit Carrier is NOTE: Not all Gen 1 Crossbars are factory drilled to shown for illustrative purposes only, and is receive accessories. If not drilled, prerform Steps 1.1 to not included with this Conduit Mounting Kit. 2.3.
- Page 4 CROSSBAR PREPARATION-FRONT Prior to drilling, mark a center line along the length of the Crossbar to ensure the holes are correctly centered. Find the center of the top of Front Crossbar between the inner bends. Using a grease pencil, mark the center, then measure out 3.50”...
- Page 5 Center the front and rear of the Conduit Carrier evenly between the Left and Right Rotations. Position the back end of the Conduit Carrier according to your rack model, but no further back than the end of the Drive Shaft. Even Varies Even...
- Page 6 CONDUIT CARRIER MOUNTINGS M8 X 25MM Bolts Flat Washer Place the Conduit Carrier Bracket into the Crossbar’s bottom groove as shown. Flat Washer Lock Nut Center the front and rear of the Conduit Carrier evenly between the Left and Right Rotations. Position the back end of the Conduit Carrier according to your rack model, but no further back than the end of the Drive Shaft.
- Page 7 ALURACK CONDUIT MOUNTING KIT INSTALLATION SEQUENCE NOTE: AluRack and Conduit Carrier is shown for illustrative purposes only, and is not included with this Conduit Mounting Kit. This Conduit Mounting Kit contains only the parts needed to repair, replace, or add one Conduit Carrier.
- Page 8 Position the Conduit Carrier anywhere between the side rails ensuring the Conduit Mountings to not interfere with the AluRack Mounting Brackets attaching the rack to the vehicle roof. The Conduit Carrier must not exceed the rear most end of the AluRack side rail. Flush Varies Varies...
- Page 9 CONDUIT CARRIER MOUNTINGS Place the Conduit Carrier Nut Brackets into the Front and Rear Crossbars as shown. Flat Washer M8 X 30MM Bolts Center the front and rear of the Conduit Carrier evenly between the Left and Right Rotations. Position the back end of the Conduit Carrier according to your rack model, but no further back than the end of the Drive Shaft.
- Page 10 Page Intentionally Left Blank...
- Page 11 Page Intentionally Left Blank...
- Page 12 USAM-CON8505-US01 Rev-D 0818...