Table of Contents
Advertisement
HOW TO OPERATE LIGHTS
Activating Lights
• There is no power switch to activate the lights on the deck.
• The lights are activated by a vibration sensor.
• Lights are activated when product is in motion.
• Lights will remain on for approximately 20 seconds after product has stopped moving. Lights are re-activated when product resumes motion. There are
total of 5 modes that can be selected.
Switching Light Modes
• Press the button at bottom of the rear deck platform to switch lights to the next mode. There are total of five (5) light modes than can be activated.
CHECK BEFORE RIDING
Always inspect your caster board's wheel bearings and other hardware to make sure they are tight before each use.
REPAIR AND MAINTENANCE
Replacing the Batteries
Required Tool: Phillips screwdriver (not included)
1
Using a Phillips screwdriver, remove the four (4)
screws from the battery cover.
2
Remove the battery cover and set aside.
3
3
Advertisement
Table of Contents
