Razor HOVERTRAX 2.0 Calibration Instructions
Hide thumbs
Also See for HOVERTRAX 2.0:
- Manual (132 pages) ,
- Owner's manual (16 pages) ,
- Owner's manual (8 pages)
Advertisement
Calibration Confirmation
Note: Your Hovertrax 2.0 should have been calibrated at the factory.
1
Place Hovertrax 2.0 on a level surface.
2
Turn power ON. If product remains level or adjusts to become
level, calibration has been confirmed. No further steps are needed.
If product begins to roll or does not move into a level orientation,
see Calibrating Hovertrax 2.0 on page 2.
Need Help? Visit our web site at www.razor.com or call 1800 244 543 or email:
info@funtastic.com.au Monday - Friday 9:00 AM - 5:30 PM.
HOVERTRAX 2.0/DLX 2.0
CALIBRATION INSTRUCTIONS
1
Advertisement
Table of Contents
Related Manuals for Razor HOVERTRAX 2.0
Summary of Contents for Razor HOVERTRAX 2.0
- Page 1 If product begins to roll or does not move into a level orientation, see Calibrating Hovertrax 2.0 on page 2. Need Help? Visit our web site at www.razor.com or call 1800 244 543 or email: info@funtastic.com.au Monday - Friday 9:00 AM - 5:30 PM.
- Page 2 While keeping the product level, turn power ON and HOLD until product beeps and lights flash (approximately 15-20 seconds). Need Help? Visit our web site at www.razor.com or call 1800 244 543 or email: info@funtastic.com.au Monday - Friday 9:00 AM - 5:30 PM.
- Page 3 161216 Need Help? Visit our web site at www.razor.com or call 1800 244 543 or email: info@funtastic.com.au Monday - Friday 9:00 AM - 5:30 PM.
Need help?
Do you have a question about the HOVERTRAX 2.0 and is the answer not in the manual?
Questions and answers