Kenwood TK-2170ST Service Manual page 10

TK-2170/2170ST
■ Zone edit mode
1. Press the [A] key so that the "▼" indicator is located on
the left side, above the zone number.
2. Rotate the selector select your desired zone number.
3. Press the [C] key to enter Zone Edit Mode.
4. Press the [C] key again to select the setting you wish to
modify.
5. Rotate the selector to select the desired value.
6. Press the [B] key to store the value in memory and ad-
vance to the next setting.
7. Press the [C] key to skip any settings you do not wish to
modify.
Press the [S] key to exit. "SELF" appears on the display.
No. Function
Zone Edit
1 Time-out Timer
2 TOT Pre-alert
3 TOT Rekey Time
4 TOT Reset Time
5 Option Signaling Decode
Condition
6 Audio Control
10
REALIGNMENT
Choices
15~1200/15s
Off, 1~10/1s
Off, 1~60/1s
Off, 1~15/1s
QT/DQT
Carrier
QT/DQT
QT/DQT and Option Signaling
QT/DQT or Option Signaling
■ Zone edit mode flow chart
Self programming mode
[Side2]
[S]
Channel select mode
[A]
[S]
Zone select mode
[C]
You cannot enter the zone edit mode
when channel data is not set
[S]
Time-out timer
[B] (Write data)
[C] (Don't write data)
[S]
TOT pre-alert
[B] (Write data)
[C] (Don't write data)
[S]
TOT rekey time
[B] (Write data)
[C] (Don't write data)
[S]
TOT reset time
[B] (Write data)
[C] (Don't write data)
[S]
Option signaling
decode condition
[B] (Write data)
[C] (Don't write data)
[S]
Audio control
[B] (Write data)
[C] (Don't write data)
Display
T O T _ _ _ 6 0 Default=60
T O T P _ O F F Default=Off
T O T K _ O F F Default=Off
T O T S _ O F F Default=Off
←Default
O P D C _ Q T _
O P D C _ C R _
←Default
A D C _ Q T _ _
A D C _ A N D _
A D C _ O R _ _
Remarks