Adjusting The Wind Direction - Panasonic CZ-RWSU3U Operating Instructions Manual

7. Adjusting the Wind Direction

• Never try to manually move the flap (up-down wind direction plate) that is
operated by the remote controller.
• When the unit stops, the flap (up-down wind direction plate) automatically
faces downwards.
• When the unit is in heating standby, the flap (up-down wind direction plate)
faces upwards. Also, bear in mind that the flap starts swinging after the
heating standby mode is released, but the display on the remote controller
indicates Auto Flap during standby heating as well.
CZ-RWSU3U/CZ-RWSD2U/
CZ-RWST2U/CZ-RWSC3
Setting the Wind Direction
While the unit is operating, every time
you press , the direction the flap
faces changes.
Setting Flap to Swing
If you press
down wind direction plate) in its most
downward facing position, and then
press again,
and the flap swings automatically up
and down.
Stopping Flap Swing
If you press
swinging, you can stop the flap from
swinging and set it in place as
desired. Thereafter, if you press
you can set the wind direction starting
from the most upward position.
When the unit is in the Cool or Dry
•
mode, the flap cannot stop facing
downwards. If you try to stop the
flap from swinging while it is facing
downwards, it will continue moving
until it is in the third position from
the top.
to set the flap (up-
is displayed
again while the flap is
In Heat Mode
Please face the flap
(up-down wind
direction plate)
downwards. If it faces
upwards, the warm air
will not reach the floor level.
In Cool or Dry Mode
Please face the flap
(up-down wind
direction plate)
upwards. If the plate
faces downwards,
condensation may
form and drip from
around the air outlet.
In Fan Mode
,
Initial setting
Displays with Swing Stopped
Fan/Heat
modes
Initial setting
Initial setting
In All Modes
Moves constantly
Cool/Dry
modes
(EN)
14