Advertisement
19/32 (15)
(Installation hole pitch)
3-3. Routing the Tubing
● The tubing can be routed out either from the front or from the bottom.
● The connecting valve is contained inside the unit. Therefore, remove the front panel.
(1) If the tubing is routed out from the front, use cutting pliers or a similar tool to cut out the tubing outlet slit (part indicated by
from the tubing cover.
For type 72/96
Front
Bottom
Remove 8 panel screws
from front panel
(2) If the tubing is routed out from the bottom, remove the slit part (
● Use a drill bit approximately 13/64" (5.2 mm) dia. to create holes at the
5 slit hole indentations (openings).
● Punch out the slit part (
● Be careful not to damage the base plate.
00_302411_EN.indd 24
Type 72/96
Air intake
29-9/64 (740)
30-5/16 (770)
A : 37-61/64 (964) [Installation hole pitch] * The tubing is routed out from the front.
B : 28-47/64 (730) [Installation hole pitch] * The tubing is routed out from the bottom.
C : 28-47/64 (730) [Installation hole pitch]
For type 120/144
Remove 10 panel screws
from front panel
).
Type 120/144
Air intake
19/32 (15)
45-9/32 (1150)
(Installation hole pitch)
46-29/64 (1180)
ex.) type72/96 (208/230 V model)
Tubing cover
Remove 3 screws
Front
Bottom
ex.) type 120/144 (208/230 V model)
Tubing cover
Remove 4 screws
Tubing cover
Slit hole
).
Tubing cover
Slit part
24
Unit: in. (mm)
Use cutting pliers or similar tool
to cut cover out
Use cutting pliers or similar tool
to cut cover out
Indentation (5 locations)
)
2018/7/4 13:27:43
Advertisement
