Electrolux FMV156EMC Service Manual page 32

FMV156EMC
1. Disconnect the power supply cord, remove the oven
from wall and remove outer case (Refer to procedure
of "Removal of oven from Wall" and "outer case
Removal".)
. open the door and block it open.
3. to discharge the high voltage capacitor, wait for 60
seconds.
4. Remove the three (3) screws holding the hood intake duct
R to the oven cavity top plate, the oven cavity front flange
and the fan duct. And remove the hood intake duct R.
5. Remove the one (1) screw holding the hood duct R to the
oven cavity top plate. And remove the hood duct R.
6. Disconnect the wire leads from the fan motor.
7. Disconnect the high voltage wire lead with the high
voltage rectifier from the magnetron.
8. Disconnect the filament lead of the transformer from the
high voltage capacitor.
9. Disconnect the high voltage wire A from the capacitor.
10. R elease the wire leads from the hole of the fan duct.
11. R emove two () screws holding the fan duct to oven
cavity top plate and the base plate R.
1. Remove the fan duct assembly from the oven cavity.
13. R emove the fan blade from the fan motor shaft according
the following procedure.
14. H old the edge of the rotor of the fan motor by using a
pair of groove joint pliers.
CAUTION:
* Make sure that any pieces do not enter the gap
between the rotor and the stator of the fan motor
because the rotor is easily shaven by pliers and
metal pieces may be produced.
* Do not touch the pliers to the coil of the fan motor
because the coil may be cut or damaged.
* Do not disfigure the bracket by touching with the
pliers.
Rear View
Coil
Groove joint pliers
Stator
Gap
Bracket
Rotor
COOLING FAN MOTOR REMOVAL
15. R emove the fan blade from the shaft of the fan motor by
16. Now, the fan blade will be free.
CAUTION:
* Do not reuse the removed fan blade because the
17. R emove the two () screws holding the fan motor to the
18. N ow, the fan motor is free.
INStAllAtIoN
1. Install the fan blade to the fan motor shaft according to
. Hold the center of the bracket which supports the shaft
3. Install the fan blade to the shaft of fan motor by pushing
4. Install the fan motor to the hood duct with the two ()
CAUTION:
* Do not hit the fan blade with excesive force when
* Make sure that the fan blade rotates smooth after
* Make sure that the axis of the shaft is not slanted.
5. Install the fan duct to the oven cavity top plate and base
6. Reconnect the wire leads to the fan motor, magnetron
7. Re-install the wire leads to the hole of the fan duct.
8. Re-install the hood intake duct R to the oven cavity top
9. Refer to procedure of "oUtER cASE REMoVAl". And
Shaft
These are the areas
Axis
that should be held
with a pliers
Stator
Rotor
Side View
3
pulling and rotating the fan blade with your hand.
hole (for shaft) may be larger than normal.
fan duct.
the following procedure.
of the fan motor on the flat table.
the fan blade with a small, light weight, ball peen hammer
or rubber mallet.
screws.
installing because the bracket may be disfigured.
installation.
plate R with the two () screws.
and high voltage capacitor, referring to the pictorial
diagram.
plate, the oven cavity front flange and the fan duct with
the three (3) screws.
reverse their procedure. And re-install the outer case.
Table
Shaft
Center of
bracket