GE GTE15 Series Use And Care Manual page 20

CLEaninG tHE tRaY
1. First, open the front door where you
see a small lip on the right-hand
side. Pull the door towards you until
completely open.
2. Then, to remove the ice-tray from its
fitting, take it by the right-hand side
and at the same time, pull it down and
towards you. Finally, pull it out by the
centre, keeping it horizontal.
3. To replace the ice-tray in the Smart
Fill Ice Factory, align the short sides
with the lateral fittings and push it
until it's completely inserted.
4. Afterwards, push the tray by the
right-hand side until you hear a click,
which will ensure the tray securely in
place while working. Close the lid of
the Smart Fill Ice Factory. Your device
will be ready for use once again.
20
iMPORtant:
Use tepid water to remove residual ice which
will form with regular use of the Smart Fill Ice Factory. This
residue could form on the lid you use to fill the water cylinder,
the cylinder valve, and the ice-box, thus affecting the working
of different parts of the system.
Don't use ice-picks, forks, or knives to remove the residual ice
as to do so could damage the Smart Fill Ice Factory.