Smart Fill Ice Factory - GE GTE15 Series Use And Care Manual

In case of a spillage, you can take the following steps to
easily clean the exterior door:
to remove and reinstall the exterior door of your
smart station you will need a small screwdriver:
1. Open the exterior access door
2. Use the flat part of the screwdriver to remove
the door from the base on the left hand side.
3. Find the hinge and put the screwdriver into it.
4. Once you have unscrewed the hinge, pull the
door to the right until it comes away.
5. To replace the door, first attach it to the bolt on
the right-hand side.
6. Slide the edge to the right using the screwdriver,
and align it with the marked groove.
7. Use light movements until you hear a click
indicating that the door is properly positioned.
18

sMaRt FiLL iCE FaCtORY

(only available with certain models)
This no-spill ice-maker with removable cylinder
feeds directly into the ice-tray. It comes with a
storage box that can hold up to 900g of ice.
WaRninG!
FiLL OnLY WitH dRinkinG WatER
staRtinG uP
Remove the water cylinder found at the top of the
SMART FILL ICE FACTORY (SFIF) by pulling the top
middle part towards you.
Once removed, place the water cylinder on a flat
surface. Open The top, which you'll find in the
middle centre. To avoid spillages, make sure that
there's no residual ice obstructing the valve of the
cylinder before you fill it with water. Pour 180 ml
of purified water into the cylinder or fill it to the
maximum level.
Replace the top, placing pressure on the middle.
It's essential that it's secure in the centre in order
to avoid water leaking out.