Table of Contents
Advertisement
Janome 6600 Instruction Manual
1
2
(A)
3
www.toews.com
1
2
(B)
Sensor buttonholes
Machine Setting
Pattern:
Thread tension:1-5
Presser foot:
Foot pressure: 3
Square Buttonhole
Buttonholes 14 and 16 to 20 are sensor buttonholes.
The size of a buttonhole is automatically set by
placing a button in the rear of automatic buttonhole
foot R.
The button holder of the foot takes a button size of
0.5 cm (3/16 ") to 2.5 cm (1") in diameter.
It is sometimes necessary to change buttonhole size
to match certain heavy or specific fabrics and
threads.
Make a test buttonhole on an extra piece of the fabric
to check your settings.
The preset width of the buttonhole is suited for
ordinary buttons.
Apply an interfacing to stretch or fine fabrics.
To sew
z
Press the up/down needle button to raise the
needle. Attach the automatic buttonhole foot R
snapping the pin into the groove of the foot
holder.
1 Groove
2 Pin
x
Pull the button holder to the back, and place
the button in it. Push it together tightly on the
button.
3 Button Holder
NOTE:
If the button is extremely thick, make a test
buttonhole on an extra piece of the fabric.
If it is difficult to fit the button through the test
buttonhole, you can lengthen the buttonhole by
pulling the button holder back a little. The length of
the buttonhole will be increased.
MC6600P Owners Manual/ User Guide
50
Janome Sewing Machine
14 (Mode 3)
Automatic Buttonhole foot R
Advertisement
Table of Contents
