TREND 40/15X1/2TC Safety Instruction

Our policy of continuous improvement means that
specifications may change without notice. Trend Machinery
& Cutting Tools Ltd cannot be held liable for any material
rendered unusable or any form of consequential loss. Trial cuts
should be made in waste material before starting any project.
© Trend Machinery & Cutting Tools Ltd. 2015 E&OE
® All trademarks acknowledged
Trend Machinery & Cutting Tools Ltd.
Odhams Trading Estate St Albans Road
Watford WD24 7TR England
Tel: 0044(0)1923 249911
technical@trendm.co.uk
www.trend-uk.com
EN847-1:2013
ROUTER CUTTER
SAFETY INSTRUCTION
Thank you for purchasing this Trend product.
This router cutter (cutting tool) must not be into service
until is has been established that the power tool to be
connected to this unit is in compliance with 2006/42/
EC (identified by CE marking on the power tool).
INTENDED USE
The router cutter is intended to be used in a routing
machine to rout wood and wood based material.
Certain specialty cutters can also be used on alloy.
SAFETY
Observe the safety regulations in the instruction
manual of the power tool and accessory/attachment
to be used. Please read the following instructions
carefully. Failure to do so could lead to serious injury.
PLEASE KEEP THESE INSTRUCTIONS IN
A SAFE PLACE.
The attention of UK users is drawn to The Provision
and Use of Work Equipment Regulations 1998, and
any subsequent amendments. Users should also read
the HSE/HSC Safe Use of Woodworking Machinery
Approved Code of Practice and Guidance Document
and any amendments. Users must be competent
in using woodworking equipment before using our
products.
Ensure working position is comfortable and
component is clamped securely. Please keep children
RECYCLABLE
and visitors away from tools and work area. All tools
have a residual risk, so therefore must be handled
with caution.