Awning (If Equipped); Hardware Adjustments; Windows/Blinds - Nucamp Cirrus 620 2021 Owner's Manual

AWNING (If Equipped)

Basic awning operating instructions:
1. Locate the awning controls inside the main entrance door.
2. Turn the awning power switch to ON.
3. Press the RETRACT or EXTEND to operate the awning.
4. A switch to control the lights on the side awning is on the switchboard located inside the
entry door.

HARDWARE ADJUSTMENTS

During travel, everything in your camper is subject to some degree of movement and cabinets may
shift slightly. Over time this can cause misalignment of cabinetry doors. The hinges installed in your
camper can be adjusted. Other installed hardware may also be adjusted. A multi-bit screwdriver will
come in handy to make these small adjustments. If you are uncomfortable or inexperienced in making
these adjustments your dealer can assist you. Use of power tools is not recommended in making small
hardware adjustments.

WINDOWS/BLINDS

Windows and blinds are affected by sunlight. When blinds are up and windows are closed, heat can
build up between the window and the blind. This trapped heat can damage both window and blind.
When camping in direct sunlight with the blinds closed, the window must be vented to release trapped
heat. In transit, the blinds must be opened to keep heat from being trapped between the window and
closed blind. Be sure to follow all manufacturer instructions and regulations relating to the blinds and
windows maintenance and safety.
44 Truck Campers • nucamprv.com