Table of Contents
Advertisement
Install the colored binding posts to the panel as shown in Figure I.
Use the hardware shown in the figure. Make sure that the small nut
is tight.
WIRING (See Figure J and Ja)
Solder the wire from hole J1 on the PC board to the first yellow
binding post as shown.
Solder the wire from hole J2 on the PC board to the second yellow
binding post as shown.
Solder the wire from hole J3 on the PC board to the black binding
post as shown.
Solder the wire from hole J4 on the PC board to the lower lug (A) of
the jack as shown.
Solder the wire from hole J7 on the PC board to the upper left lug (C)
on the jack as shown.
Solder the wire from hole J8 on the PC board to the upper right lug
(B) on the jack as shown.
Wire from
Point J7
Wire from
Point J4
Wire from
Point J8
Wire from
Point J1
Wire from
Point J2
Wire from
Point J3
(C)
Side Lug (A)
-6-
Nut
Lockwasher
Backside of
Small Nut
Binding Post
Black
Yellow
Yellow
Figure I
Figure J
Component Side
of PC Board
(B)
Attach the wires
to the lugs before
soldering.
Figure JA
Panel
Advertisement
Table of Contents
