Table of Contents
Advertisement
ASSEMBLE COMPONENTS TO THE PC BOARD
R2 - 10kW Potentiometer
Hex Nut 7mm
(see Figures Ea & Eb)
S1 - 6 position Rotary Switch
(see Figure F)
R3 - 100kW Potentiometer
(see Figures Ea and Eb)
Battery Snap
(see Figure G)
Figure Ea
Mount the pot down flush with the PC
board. Solder and cut off excess leads.
INSTALL COMPONENTS TO FRONT PANEL
Install the jack to the panel with the side lug facing the direction shown in Figure H. Fasten the jack in place
with the round nut from the front side of the panel.
Cut off tab
Put a 7mm hex nut onto the pot as
shown.
Jack
Figure Eb
Side Lug
Back Side
of Panel
Round Nut
-5-
Figure F
Cut off tab
Mount down
flush with PC
board.
Figure G
Thread the battery snap wires
through the hole in the PC board
from the solder side as shown.
Solder the red wire to the BT+
point and the black wire to the BT--
point on the PC board.
Red Wire (BT+)
Black Wire (BT--)
Red Wire (BT+)
Black Wire (BT--)
Figure H
Advertisement
Table of Contents
