Table of Contents
Advertisement
The throttle lever is spring loaded and
should return to rest position (idle)
when not pressed.
R R i i g g h h t t C C o o n n t t r r o o l l l l e e r r
The right controller is located on the
RH side of the handlebar.
The right controller includes controls
to navigate in the multifunction gauge.
– Arrow UP
– Arrow RH
– Arrow Down
– Arrow LH
– OK button.
B B R R P P C C o o n n n n e e c c t t B B u u t t t t o o n n
The BRP Connect button is located
above the right controller.
This button allows a quick access to
BRP Connect. Each click will swap
between apps view and functions view
of the multifunction gauge.
E E n n g g i i n n e e C C u u t t - - O O f f f f S S w w i i t t c c h h
The engine cut-off switch is located in
the middle of the handlebar.
To allow engine starting, the tether
cord cap must be securely snapped to
the engine cut-off switch.
W W A A R R N N I I N N G G
A A l l w w a a y y s s a a t t t t a a c c h h t t h h e e t t e e t t h h e e r r c c o o r r d d c c l l i i p p
t t o o t t h h e e o o p p e e r r a a t t o o r r ' ' s s p p e e r r s s o o n n a a l l f f l l o o t t a a - -
t t i i o o n n d d e e v v i i c c e e ( ( P P F F D D ) ) o o r r w w r r i i s s t t ( ( w w r r i i s s t t
s s t t r r a a p p r r e e q q u u i i r r e e d d ) ) . .
T T Y Y P P I I C C A A L L
1. Tether cord cap on the engine cut-off switch
2. Tether cord secured to operator's PFD
To stop engine, pull the tether cord
cap from the engine cut-off switch.
W W A A R R N N I I N N G G
S S h h o o u u l l d d t t h h e e e e n n g g i i n n e e b b e e s s t t o o p p p p e e d d , , t t h h e e
b b r r a a k k e e f f u u n n c c t t i i o o n n a a n n d d a a l l l l w w a a t t e e r r c c r r a a f f t t
d d i i r r e e c c t t i i o o n n a a l l c c o o n n t t r r o o l l i i s s l l o o s s t t . .
CONTROLS
59
Advertisement
Table of Contents
