Configuration Procedure Of Module; Notes For Aux; Operating Mode - Ebyte E34-2G4D27D User Manual

Chengdu Ebyte Electronic Technology Co., Ltd.

5.2.3.Configuration procedure of module

Only happened when power-on resetting or exiting sleep mode.

5.2.4. Notes for AUX

For function 1 & function 2 mentioned above, the priority should be given to the one with low level output, which means if it

meets each of any low level output condition, AUX outputs low level, if none of the low level condition is met, AUX outputs
high level.
When AUX outputs low level, it means the module is busy & cannot conduct operating mode checking. Within 1ms since AUX

outputs high level, the mode switch will be completed.
After switching to new operating mode, it won't be work in the new mode immediately until AUX rising edge 2ms later.

AUX is on the high level, the operating mode switch can be effected immediately.
When the user switches to other operating modes from mode 3 (sleep mode) or it's still in reset process, the module will reset

user parameters, during which AUX outputs low level.

6. Operating mode

The module has 4 operation mode, which decided by the status of M1 & M0. Below are the details:
Mode（0-3）
Mode 0
Half-Duplex
Mode 1
Full-Duplex
Mode 2
Reservation Mode
Mode 3
Setting Mode
Copyright ©2012–2018, Chengdu Ebyte Electronic Technology Co.,Ltd.
M0 M1
UART and wireless channel are open,
0 0
transparent transmission is on ， half- duplex
operation
UART and wireless channel are open,
1 0 transparent transmission is on ， full- duplex
operation
0 1 Reservation Mode
1 1 Parameter setting
Description
E34-2G4D27D User manual
Remark
The receiver must work at same address,
channel and same baud rate.
The receiver must work at same address,
channel and same baud rate.
The same as that in mode 0.
If
7