Indication Of Wireless Transmitting; Configuration Procedure Of Module; Notes For Aux - Ebyte E61 Series User Manual

Wireless UART Module

5.2.2 Indication of Wireless Transmitting

Buffer (empty): the internal 256 bytes data in the buffer are written to the RFIC (Auto sub package). When AUX=1, the user can input data
less than 256 bytes continuously without overflow.
Buffer (not empty): when AUX=0, the internal 256 bytes data in the buffer have not been written to the RFIC completely. If the user starts
to transmit data at this circumstance, it may cause overtime when the module is waiting for the user data, or transmitting wireless sub
package.
Notes: When AUX = 1, it does not mean that all the UART data of the module have been transmitted already, perhaps the last packet of
data is still in transmission.

5.2.3 Configuration Procedure of Module

Only happened when power-on resetting or exiting sleep mode.

5.2.4 Notes for AUX

For function 1 & function 2 mentioned above, the priority should be given to the one with low level output, which means if it meets
l
each of any low level output condition, AUX outputs low level, if none of the low level condition is met, AUX outputs high level.
When AUX outputs low level, it means the module is busy & cannot conduct operating mode checking. Within 1ms since AUX
l
outputs high level, the mode switch will be completed.
After switching to new operating mode, it won't be work in the new mode immediately until AUX rising edge 2ms later. If AUX is
l
on the high level, the operating mode switch can be effected immediately.
When the user switches to other operating modes from mode 3 (sleep mode) or it's still in reset process, the module will reset user
l
parameters, during which AUX outputs low level.
Copyright ©2012–2017, Chengdu Ebyte Electronic Technology Co., Ltd.
User Manual of E61 Series Modules
10 / 18