Table of Contents
Advertisement
Print Speed
Tear Off
Print mode
Print Width
List Fonts
List Images
List Formats
List Setup
Control Prefix
Format Prefix
Delimiter Char
Media Power Up
Head Close
Label Top
Left Position
Use this item to setup print speed. The each increase or
decrease is 1 ips. Available setting is from 2 to 6.
This item is used to fine tune media stop location. Available
setting value is from "+" to "-" or "0" to "9".
This item is used to set the print mode. There are 3 modes as
below,
Printer Mode
Description
Next label top of form is aligned to the print
Tear Off
head burn line location.
Peeler Off
Enable the label peel off mode.
Cutter
Enable the label cutter mode
This item is used to set print width. The available value is from
"0" to "9".
This feature is used to print current printer available fonts list to
the label. The fonts stored in the printer's DRAM, Flash or
optional memory card.
This feature is used to print current printer available images list
to the label. The images stored in the printer's DRAM, Flash or
optional memory card.
This feature is used to print current printer available formats list
to the label. The formats stored in the printer's DRAM, Flash or
optional memory card.
This feature is used to print current printer configuration to the
label.
This feature is used to set control prefix character.
This feature is used to set format prefix character.
This feature is used to set delimiter character.
This option is used to set the action of the media when you turn
on the printer.
Selections
Description
Feed
Printer will advance one label
Printer will calibration the sensor levels,
Calibration
determine length and feed label
Length
Printer determine length and feed label
No Motion
Printer will not move media
This option is used to set the action of the media when you close
the print head.
Selections
Description
Feed
Printer will advance one label
Printer will calibration the sensor levels,
Calibration
determine length and feed label
Length
Printer determine length and feed label
No Motion
Printer will not move media
This option is used to adjust print position vertically on the label.
The range is -120 to +120 dots.
This option is used to adjust print position horizontally on the
- 45 -
6 (203dpi)
4 (300dpi)
3 (600dpi)
+000
Tear Off
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
No
Motion
No
Motion
0
+0000
Advertisement
Table of Contents
