Advertisement
Quick Links
Maintenance
Abrasive Containment and Disposal
Empty the abrasive hopper by placing a pail
or plastic bag under either of the hopper
outlets and open the valve.
Empty the container and repeat as needed.
Warning: Excessive abrasive in the hopper may
cause powder to leak through vent holes.
Filter Cleaners
Filter cleaning mallets are located on both
sides of the ProCenter Plus. Before each
shift, with the power turned off, pull and
release the mallets two or three times.
This action will dislodge spent media that
may have collected in the HEPA filter.
Changing the HEPA Filter
Remove any equipment sitting
on top of the filter box.
Disconnect the power cords
on both sides of the filter box.
Remove filter box cover.
Remove and replace filter.
(CTR280‐1 Replacement HEPA
filter assembly)
Air Dryer Maintenance
The desiccant inside the air dryer bowl will gradually turn from bright
orange to dark green as it becomes saturated. Change according to
the instructions included with the
air dryer.
For maintenance instructions on your
air dryer, please see manual "AD5100
Series – Desiccant Air Dryer."
ProCenter Plus
Manual
NEED HELP?
Comco Tech Support: 818‐841‐5500
Tech@comcoinc.com
8/2021
www.comcoinc.com
TS414
Advertisement
Related Manuals for Comco ProCenter Plus
Summary of Contents for Comco ProCenter Plus
- Page 1 Empty the container and repeat as needed. Warning: Excessive abrasive in the hopper may cause powder to leak through vent holes. Filter Cleaners Filter cleaning mallets are located on both sides of the ProCenter Plus. Before each shift, with the power turned off, pull and release the mallets two or three times. This action will dislodge spent media that may have collected in the HEPA filter. Changing the HEPA Filter Remove any equipment sitting on top of the filter box. Disconnect the power cords on both sides of the filter box. Remove filter box cover. Remove and replace filter. (CTR280‐1 Replacement HEPA filter assembly) Air Dryer Maintenance The desiccant inside the air dryer bowl will gradually turn from bright orange to dark green as it becomes saturated. Change according to the instructions included with the air dryer. NEED HELP? Comco Tech Support: 818‐841‐5500 For maintenance instructions on your Tech@comcoinc.com www.comcoinc.com air dryer, please see manual “AD5100 Series – Desiccant Air Dryer.” 8/2021 TS414...
- Page 2 HAND‐ used for operating other PIECE equipment. HOSE Air Pressure Regulators BLASTER POWER There are two air regulator controls on the CORD electronics box located on back of the unit. POWER • Air Purge: regulates flow to the air jets; CORD VENT prevents abrasive from accumulating in HOSE front of the work chamber. Note: There should always be air flowing out of the air jets SHOP • Blow‐Off: sets air pressure on the blow‐off AIR FROM DRYER The air pressure regulators are preset at the Before you set up and operate your Comco TO AIR factory for reasonable air flow and should blaster, read and follow DRYER not require adjustment with the demands the safety instructions in of normal production. your Maintenance Manual.
Need help?
Do you have a question about the ProCenter Plus and is the answer not in the manual?
Questions and answers