Sharp VT-G14 Service Manual page 43

INSTALLING THE SHIFTER
Capstan
D.D. motor
Reel pulley
(Bottom side of mechanism chassis)
Figure 1-42.
1. Make sure that the loading gear is at the phase-
2. Install, paying attention to 5 insertion points and 3
3. For the phase matching at the insertion point 1, see
Drum
4. Finally fix the inserts 1 and 4.
Insert
point 3
Insert
point 2
Shaft 1
Rotation
point 2
Shaft 1
Phase-matching
point 1
Figure 1-43.
43
matching point 1 as shown below.
release points.
the phase-matching point 2 as shown below.
Phase-Matching
point 2
Loading gear(T)
Round mark
Insert
point 1
Sifter
Shaft 1
Half round notch
Insert
point 4
Shaft 2
Release
point 3
VT-G14
VT-G21
Insert
point 5