NOTE Please check you have all hardware before assembling. If you are missing any hardware, please contact the store of purchase. Please ensure you have the name of the item, required hardware part and quantity. Please retain your receipt as proof of purchase to validate your warranty. CAUTION Do not tighten screws before all screws are in the right place.
STEP 1 Fix six (6) PINS (B) into the pre-drilled holes at the tops of your end panels & division with your screwdriver. NOTE: these pre-drilled holes are slightly offset to the edge. DIVISION LH END RH END STEP 2 Knock in your ARRERTS (A) into the pre-drilled holes on the inside of your end panels (two per end panel).
Page 4
STEP 5 Align the CAM HOUSING on your end panels with your PINS (B) on your back panel. Tighten by rotating the screw to the right hand side. Place division in centre and align the top with the PINS (B) on both the ends & division, tighten with your screw driver.
Page 5
STEP 7 Place the assembled unit to its required position and insert 32MM SCREW (C) into the top of your ARRET (A) and drive into top with force using your screw driver NOTE: Be careful not to over tighten. STEP 8 To insert shelves, place your SHELF SUPPORTS (D) in the holes on the end panels at the desired shelf...