Recom RCM-4-TP-D User Manual page 16

2) Use an electrical driller with 10mm diameter bit to drill 5 holes on the wall and make sure
hole depth is 80mm.
Warning
3) Insert the expansion tubes into the holes and tighten them, then fix the bracket onto the
wall with expansion screws by using a cross screwdriver, as shown in Figure 4-6:
4.2.2 Mounting the inverter
Lift up the inverter with both hands, hang the back rail on the fixed wall bracket carefully, see
Figure 4-7 for details:
16
Before drilling, make sure to avoid the buried water tube and electric wires
in the wall to avoid danger.
Figure 4-6 Fix the wall bracket
Figure 4-7 Mounting the inverter