Laser Function (Fig. 12); Cleaning And Maintenance; Maintenance; Service Department - VARO POWERplus POW8136 Manual


Turn the flange bolt until it is completely removed.

Take the blade (5) off the inner flange and pull out downwards.

Mount the new saw blade in reverse order and fasten.

Important! The cutting bevel of the teeth, i.e. the direction of rotation of the saw blade, has
to conform with the direction of the arrow marked on the housing.

Clean the saw blade flanges thoroughly before mounting the saw blade.

Reattach the movable blade guard (6) in reverse order.

Before using the saw again, check that the safety devices are in good working order.

Important: Every time that you change the saw blade, check to see that it spins freely in
the groove of the turntable in both perpendicular and 45° angle settings.

13 LASER FUNCTION (FIG. 12)

You can switch the laser ON and OFF with the switch (a).
The laser (35) directs a beam onto the work-piece.
Extremely precise cuts can be made using the laser function.

14 CLEANING AND MAINTENANCE

Attention! Before performing any work on the equipment, pull the power
plug.
14.1

Maintenance


Keep the machine's air vents unclogged and clean at all times.

Remove dust and dirt regularly from the machine. Cleaning is best done with compressed
air or a rag.

Re-lubricate all moving parts in regular intervals.

Never use caustic agents to clean plastic parts.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.

15 SERVICE DEPARTMENT


Damaged switches must be replaced by our after-sales service department.

If the connecting cable (or mains plug) is damaged, it must be replaced by a particular
connecting cable which is available from our service department. Replacement of the
connecting cable must only be carried out by our service department (see last page) or by
a qualified person (qualified electrician).
Copyright © 2014 VARO
POW8136
P a g e | 9
EN
www.varo.com