Mounting Hole Specifications - Qlight QTG-WIZ User Manual

Buzzer Sound Volume Adjustment Instructions

Mounting Hole Specifications

■ QTG60ML-WIZ / QTG70ML-WIZ - Direct Mounting Type Model
Machine holes on the mounting surface referring to the diagram below.
①
3-Ø5 HOLES
Min.Ø5 CABLE ENTRY
PCD 30
Remove the flange nuts from bolts and place the product through the mounting surface holes.
②
Fasten the flange nuts on the opposite side of the mounting surface until the product is tightened securely.
③
Mounting Accessories (Sold Separately)
• Please refer to the dimensions below for installation of mounting brackets.
■ QTG60ML-WIZ/ QTG70ML-WIZ -
QTG60 series
QTG70 series
Buzzer volume is reduced by sliding
the volume control lever to the left
as show in the diagram to the left.
( Min. 65±4dB/m )
3-Ø5 HOLES
Min.Ø5 CABLE ENTRY
PCD 40
QTG60ML-WIZ
Direct Mounting Type Model
TWS45
TWS80
3-Ø5 HOLES
Min.Ø5 CABLE ENTRY
PCD 50
QTG70ML-WIZ
Dimensions
13
Raise/ Increase the buzzer volume
by sliding the control lever to the
right as shown in the diagram to
the left.
( Max. 85±4dB/m )
TWA45
TWA80