Advertisement
wall bracket notches against these fixing points to check that
the heater complies with the "minimum operating distances".
These two fixing points should then be drilled and plugged.
Suitable round headed size 8 screws should be fixed in these
positions to such a depth that the heater may be hung in
position while the positions of the lower fixing holes are
marked, Step 2. The heater should then be removed while the
lower fixing holes are drilled and plugged. Then the heater
should be hung in position on the upper two screws while the
lower two screws are tightened to hold the heater firmly on
the wall. The tightness of the upper screws should be adjusted
if necessary to ensure a firm fit.
FIXING TO THE FLOOR
The heater may be fixed to the floor in the lay-flat position. Before fixing the heater in
position place it in the desired position and check that it complies with the requirements
described in the section "Heater Dimensions and Minimum Operating Distances".
For guidance on fixing the heater see the section on 'Fixing to the Wall". The principles
involved are the same.
User Controls
The other settings represent a range of temperatures dependent on a number of factors
including the size of the area to be heated and the outside temperature Actual settings
should be found by experience for each set of conditions.
The heater will not emit heat if the temperature of the air surrounding the heater is
above that set on the control knob, although the mains neon indicator will glow showing
that the heater is available for use. The heating element will energise if the thermostat
knob setting is increased, as indicated by an audible "click" when the thermostat knob
is turned.
Step 1
1 0 0
m m
Upper Wall Fixing Bracket
Step 2
NEON INDICATOR
When your heater is plugged in and switched on at
the mains, the neon indicator will glow showing that
the heater is available for use, although the heating
element may not be energised, depending on the
setting on the thermostat knob.
THERMOSTAT
The thermostat knob is calibrated with a scale
marked ' ' upto marked graphics. The lowest setting
' ' is designed to switch on in a temperature range
of approximately 3°C to Minus 5°C and is suitable
for frost protection.
Step 1
1 0 0
m m
Upper Wall Fixing Bracket
Step 2
5
Advertisement
