Blue Point Engineering Wizard - VIII Instruction

Blue Point
Engineering
Wizard - VIII Board
(BPE No. WAC-0080)
The Wizard - VIII Controller Board provides a
single channel, digital output combined with a 4 minute
duration sound chip.
The board incorporates such features as recorded
looping playback, variable delay between recorded
programmed routines, auto loop, auto start-up on
power start, a connection terminal for remote switch
activation by manual switch, PIR sensor, pressure pad,
etc, to activate playback routines.
Sound recording is direct to digital sound chip, and
can be done from a computer sound port, CD player or
any sound source with audio output connections.
Recording output sessions are built up on a
channel-by-channel basis - no complex programming
is needed or connection to a host computer to program
routines. All programming is easily done on-board the
controller through push button switches and LED
status indicators.
WIZARD - VIII BOARD FEATURES:
• 1 - selectable on-board relays ( 2 Amp @ 30 Volts dc ).
• Relays have insert wire terminal connection blocks.
• 1 - direct Digital control signal 0 - 4.5 Volts dc -10 mA connection pads, for hard wiring to board outputs.
• On-board potentiometer to determine the time delay between playback loops during automatic loop play,
fully adjustable between 0 and 65 seconds.
• On-board GO and DIGITAL control buttons.
• Record EEprom for recorded programming routines and Digital 4 minute Sound IC Chip.
• On-board AUTO-PLAY and LOOP-PLAY switches / jumpers.
• On-board Status LED's ( Green -Relay ON and Red - Recording ).
• Battery remote operation or wall power operation.
• Remote terminal block activation connection for manual start switch, pressure mat or PIR sensor.
• EEPROM - containing the programmed data, can be removed and copied to other Wizard - VIII boards.
• Synchronization output signal to activate other Wizard boards.
• Board is powered from regulated 9 Volts dc power supply or can be run from optional Remote Battery
operation for mobile setup.
• Power supply polarity protection on-board to prevent board electronics damages.
• Ability to share a common power connection when multiple device set-up is needed.
• REM - board trigger input with sensor H or L signal activation jumper.
• Many more unique features.
Pointing the Way to Solutions!
WIZARD - VIII BOARD
Board Size: 4" L x 4" W x 1/2"H
Wizard - VIII Board is pre-assembled and tested.
Regulated 9 Volt dc power supply @ 0.5 Amp
power supply required.
Board Size: 3-5/8" L x 3-7/8" W x 1/2" H
Instruction I
www.BPEsolutions.com
Controller
Page 1