Table of Contents
Advertisement
WARNING
Do not exceed maximum recommended air pressure
marked on the tool. Verify prior to using the tool that the air
source has been adjusted within the rated air-pressure
rang. Be sure the air pressure gauge is operating properly
and check it at least twice a day. Tools operated in excess
of their maximum pressure rating may operate abnormally
or burst resulting in personal injury.
To connect the tool to the compressor only use pneumatic
air hoses that meet the following criteria:
1.
Minimum hose pressure rating, 200PSI.
2.
Minimum hose inner diameter, 1/4 in.
3.
Maximum hose length, 100 ft.
Connect the air supply:
Snap the air hose onto the quick connector.
Check for air leakage. If leakage is noted, stop using the
tool immediately and performed by qualified repair
personnel.
Be sure the air pressure gauge is operating properly and
check it at least twice a day.
TOOL TESTING
DANGER
OPERATORS AND OTHERS IN WORK AREA MUST WEAR
SAFETY GLASSES WITH SIDE SHIELDS WHICH CONFORMS
TO ANSI Z87.1 SPECIFICATIONS.
WARNING
Before actually beginning the nailing work, test the tool by
using the check list below. Conduct the test in the following
order.
If abnormal operation occurs, stop using the tool and
performed by qualified repair personnel immediately.
Disconnect air hose from tool. Remove all nails from
1.
tool.
ALL SCREWS MUST BE TIGHTENED.
loose, tighten them.
TRIGGER MUST MOVE SMOOTHLY.
Adjust the air pressure to 60PSI, connect the air hose.
2.
Do not load any nails in the tool.
THE TOOL MUST NOT LEAK AIR.
Remove the finger from the trigger .
3.
4.
5.
6.
FIG. 4
NAIL LOADING
When loading the tools magazine, check that the nail tips
contact the wear rail and slide smoothly against the surface
of the magazine. If the nails are not loaded properly, the
tool will misfire and nails can be deflected, causing the tool
to react in an unexpected manner, and damage the tool.
1.
2.
3.
4.
5.
FIG. 5
If any screws are
5
THE TOOL MUST NOT OPERATE.
Point the tool downward, pull the trigger and then wait in
that position for 5 seconds or longer.
THE TOOL MUST NOT OPERATE.
1). Without touching the trigger, Pull the trigger.
THE TOOL MUST OPERATE
2). Hold the trigger back.
The tool will remain in operated status(the driver blade
will remain at the bottom).
3). Remove the finger from the trigger.
Tool operation will end (the driver blade will return to the
top).
If no abnormal operation is observed, you may load
nails. Drive nails into the workpiece that is the same type
to be used in the actual application.
THE TOOL MUST OPERATE PROPERLY.
WARNING
Connect air supply.
Press magazine latch and pull magazine to open
position (FIG 5).
See tool specification to determine appropriate nail
sizes. Insert appropriate nail strips, with the nail tips
contacting the wear rail (FIG 6).
Push the nail strip against the nose.
Push magazine fully closed. Magazine latch will maintain
fully closed position.
PULL OPEN
PRESS
Advertisement
Table of Contents
