1. Manuals
  2. Brands
  3. GMI Manuals
  4. Racks & Stands
  5. EL-200
  6. Assembly instructions

GMI EL-200 Assembly Instructions

Hide thumbs
1
2
3
4

Advertisement

Table of Contents

TOOLS REQUIRED FOR ASSEMBLY

Electric Hand Drill, 3/8" magnetic hex bit, 3/8" Crescent Wrench, Tape Measure.

BEFORE ASSEMBLING THE RACK

Read through the assembly instructions to familiarize yourself with the order in which the parts are assembled.
We suggest that you clear & vacuum the area where the bench is to be assembled.
It is important that the bench is assembled in the same sequence as instructed.

HARDWARE

All assembly hardware is provided. Floor Anchor hardware is not provided.
EL-200 ASSEMBLY INSTRUCTIONS
WARNING!
THIS RACK MUST
BE FLOOR
ANCHORED

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EL-200 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for GMI EL-200

Summary of Contents for GMI EL-200

  • Page 1 EL-200 ASSEMBLY INSTRUCTIONS TOOLS REQUIRED FOR ASSEMBLY Electric Hand Drill, 3/8" magnetic hex bit, 3/8" Crescent Wrench, Tape Measure. BEFORE ASSEMBLING THE RACK Read through the assembly instructions to familiarize yourself with the order in which the parts are assembled.
  • Page 3 Identify components using the illustration above. Caution - It is important to orient the back support angles (part #1) correctly. Measure the distance from one end to the center of the third hole. The distance from the top of the upright to the third hole is 33-1/2", from the bottom to the third hole is 32".
  • Page 4 Bolt Direction Bottom (2 holes) Set (#10A-C) shorts panels onto the shelves. Attach the (3- #7 & 1- #8) left & right uprights. The bottom of the uprights have 2 holes, the tops have just 1. Run the bolt down through the (1 hole) upright, into the shelves face.

Table of Contents