Tires; Body, Deck, And Upholstery - Scag Power Equipment Freedom Z SFZ36-18FS Operator's Manual

Section 7
C. BLADE REPLACEMENT
WARNING
Always wear proper hand and eye protection when
working with cutter blades.
1. Remove the ignition key before replacing the blades.
2. Raise the mower deck to the highest position. Place
the lanyard pin in the highest cutting height position
to prevent the cutter deck from falling.
3. Secure the cutter blades to prevent them from
rotating, (use the optional Blade Buddy tool P/N
9212, to assist in securing the cutter blades), remove
the blade attaching bolt. Remove the cutter blade,
bolt, lockwasher and flatwasher from the spindle
shaft. See Figure 7-9.
4. To install the new cutter blade, put the lockwaher and
flatwasher onto the blade bolt and slide the bolt into
the hole in the cutter blade.
CUTTER BLADE
LOCKWASHER
5/8-11 x 1-1/2" HEX HEAD BOLT
TORQUE TO 75 FT/LBS
Figure 7-9. Blade Replacement
- NOTE -
Be sure that the blade is installed with the lift wing
toward the top.
5. Install the cutter blade onto the cutter spindle shaft.
Secure the blades from rotating and torque to 75 ft/
lbs. See Figure 7-9.

7.9 TIRES

Check the tire pressures after every 8 hours of operation
or daily.

7.10 BODY, DECK, AND UPHOLSTERY

1. After each use, wash the mower and cutter deck.
2. Do not spray electrical components.
3. Use a mild soap solution or a vinyl/rubber cleaner to
4. Repair damaged metal surfaces using Scag touch-
FLATWASHER
35
Caster Wheels
Drive Wheels
CAUTION
Do not wash any portion of the equipment while it
is hot. Do not wash the engine; use compressed
air.
Use cold water and automotive cleaners. Do not use
pressure cleaners.
clean the seat.
up paint available from your authorized Scag dealer.
Wax the mower for maximum paint protection.
R
25 PSI
8 PSI