Part 1 - Installation; Introduction - Drolet TUNDRA II Installation And Operating Instructions Manual

Tundra II Furnace Installation and Operation Manual
PART 1 – INSTALLATION
Please see Part 2 for operation, maintenance and troubleshooting instructions.
Please see Part 3 for features and safety instructions.

INTRODUCTION

This furnace uses the same wood burning technology as a high efficiency certified CSA
B415.1-10. This model meets the emissions limits of CSA B415.1-10 Standard.
• We recommend that our woodburning hearth products be installed and serviced by
professionals who are certified in the United States by NFI (National Fireplace
®
Institute ) or in Canada by WETT (Wood Energy Technical Training) or in Quebec by
APC (Association des Professionnels du Chauffage).
BEFORE STARTING THE INSTALLATION, READ ALL THE INSTRUCTIONS BELOW
AND MAKE SURE YOU UNDERSTAND THEM. (IF IN DOUBT, CONTACT OUR
CUSTOMER SERVICE AT TECH@SBI-INTERNATIONAL.COM). FAILURE TO COMPLY
WITH THESE INSTRUCTIONS MAY RESULT IN HAZARD TO YOUR SAFETY AND
WILL AUTOMATICALLY VOID THE WARRANTY.
Inspect the furnace to make sure that nothing has been damaged in the shipping. Pull out
the tools from the flue pipe and/or exchangers and firebox of the furnace.
FOR, INSTALLATION OF A CENTRAL HEATING VENTILATION SYSTEM, IT IS
HIGHLY RECOMMENDED TO CONSULT A HEATING SYSTEM VENTILATION
SPECIALIST.
N.B.: STOVE BUILDER INTERNATIONAL INC. IS NOT RESPONSIBLE FOR POOR
APPLIANCE PERFORMANCES, DUE TO IMPROPER INSTALLATION OF EXHAUST
SYSTEM OR DUCTING.
6
IMPORTANT NOTE