MODELS: DFI-550-41, DFI-550-42, DFI-550-43,DFI-550-44,DFI-550-45,DFI-550-47
Go to tsicustomerservice.com for product warranty registration
ASSEMBLY INSTRUCTIONS
1
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
-- POWER
1. The power button supplies power to all of the fireplace functions. The power
button will put the insert in a standby mode. This will turn off all functions at
once, but will hold the settings in the memory. By pressing the Power button
again, the unit will turn on with the retained settings.
2. With the power on, press and hold the Power button on the control panel for
10 seconds to disable or re-enable the heater function. Once disabled or re-
enabled, the ember bed lights will flash multiple times.
-- FLAME
1. There are 5 brightness levels that can be selected and OFF (00) setting.
2. Settings F5 - F1 decrease in brightness. Default is F5.
-- HEATER
1. The stove contains a fan forced infrared element heater.
2. The default temperature is 72°F.
3. The thermostat setting range is 62°F - 82°F (17°C - 27°C) or continuously ON or OFF(00).
4. The thermostat is adjustable by 2°F or 1°C increments by pressing the HEATER button
on the control panel.
5. To change between °F and °C press and hold the HEATER button on the control panel
for 3 seconds.
-- TIMER
1. Pressing the timer button will cycle through the timer settings: 30 minutes, 1 Hour,
2H, 3H, 4H, 5H, 6H, 7H, 8H, 9H and off (00).
Manufactured and distributed by Twin-Star
International, Inc., under license from Duraflame,
Inc. duraflame, the flame symbol and logo are
registered trademarks of Duraflame, Inc.
2
Control Panel Location
Twin-Star International, Inc.
Delray Beach, FL 33445
Made in China
3
Remote Control
PRODUCT SPECIFICATIONS
VOLTAGE
AMPS
WATTS
For Customer Service:
tsicustomerservice.com
(+1) 888-674-7517
8:30 a.m.-5:30 p.m., EST, Monday-Friday
Note: When first running the heater there may
be an odor. This is normal as the heater has a
surface coating on the internal parts. For the
first several hours of operation, the coating
reacts with the internal parts to permanently
protect them. The odor is safe; if you are
sensitive to the odor, it is recommended
to run the heater in a well-ventilated area until
the odor dissipates.
Warning: This is an unvented, electric appliance.
DO NOT attempt to burn wood or manufactured
firelogs in or on this appliance or grate.
© 2018,Twin-Star International,Inc.
MOUNTING THE LEGS
1) Align the 2 mounting
tabs into the bracket.
2) Slide the legs outward
to lock in place. When
locked in position the
screw hole from step
3 will be aligned.
3) Fasten the legs to the
base using the included
screws,1 per leg.
Control Panel
120 VAC, 60 Hz
12.5 Amps
1500 Watts
Made in China
A657