Important Safety Instructions - Electrolux ICON Professional E30DF74GPS Installation Instructions Manual

30" & 36" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS
(91.1 cm Min.)
If there is a wall:
9" Min.
(22.9 cm Min)
Left side
G
F
Grounded
Wall Outlet or
junction box
location
Do not pinch the power supply cord between the range
and the wall.
Do not seal the range to the side cabinets.
A. HEIGHT B. WIDTH
41 5/8" (105.7 cm) Min. 35 7/8"
42 5/8" (108.3 cm) Max. (91.1 cm)
Important Notes to the Installer
1. Read all instructions contained in these installation
instructions before installing range.
2. Remove all packing material from the oven
compartments before connecting the electrical supply
to the range.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consumer.
5. Note: For operation at 2000 ft. elevations above see
level, appliance rating shall be reduced by 4 percent
for each additional 1000 ft.
Important Note to the Consumer
Keep these instructions with your owner's guide for future
reference.
Optional Items Available:
• A Cooktop Trim, if you want to remove the actual 6"
Stainless Steel Backsplash.
• A 9" (22.9 cm) Stainless Steel Backsplash
• A 12" (30.5 cm) Stainless Steel Backsplash
Those kits can be ordered for purchase through an Electrolux
Service Center at 1-877-4ELECTROLUX (1-877-435-3287).
(Model with Electric Oven and Gas Cooktop)
35 7/8" Min.
See
note
18" Min.
(45.7 cm Min.)
If there is a wall:
9" Min.
(22.9 cm Min.)
Right side
24" Min.
(61 cm Min.)
24 1/2" Max.
(62.2 cm Max.)
Figure 2 - 36" Range (30" Range, see page 1)
C. DEPTH TO
FRONT OF RANGE
27 ½" 35 3/4" (90.8 cm) Min.
(69.9 cm) 36 3/4" (93.3 cm) Max.
13" Max.
(33 cm Max.)
D
NOTE: 28" (71.1 cm) minimum clearance between the
cooktop and the bottom of the cabinet when the bottom
of wood or metal cabinet is protected by not less than
1/4" (0.64 cm) flame retardant millboard covered with
not less than No. 28 MSG sheet metal, 0.015" (0.4 mm)
stainless steel, 0.024" (0.6 mm) aluminum, or 0.020"
(0.5 mm) copper.
34" (86.4 cm) minimum clearance when the cabinet is
unprotected.
D. HEIGHT OF E. DEPTH WITH
COOKTOP DOOR OPEN
47 3/8"
(120.3 cm)
IMPORTANT SAFETY
INSTRUCTIONS
Installation of this range must conform with local codes
or, in the absence of local codes, with the National Fuel
Gas Code ANSI Z223.1—latest edition.
When installing in a manufactured (mobile) home,
installation must conform with Manufactured Home
Construction and Safety Standard, title 24CFR, part 3280
[Formerly the Federal Standard for Mobile Home
Construction and Safety, title 24, HUD (part 280)] or,
when such standard is not applicable, the Standard for
Manufactured Home Installation, ANSI Z225.1/NFPA
501A-latest edition, or with CAN/CSA-Z240 MH, or with
local codes .
This range has been design certified by CSA
international. As with any appliance using gas and
generating heat, there are certain safety precautions you
should follow. You will find them in the Use and Care
Guide, read it carefully.
2
C
B
E
F. HEIGHT OF G. MINIMUM
COUNTERTOP CUTOUT WIDTH
36" (91.4 cm) Standard
35 3/4" (90.8 cm) Min.
A
36 1/16"
(91.6 cm)