Table of Contents
Advertisement
D e t e c t i o n
D e t e c t i o n
8. Service & Maintenance
8.1 GENERAL
In view of the significance of the accuracy of measuring results, the test device must be treated with care. Dirt must be
avoided at all times, especially at the high-pressure connection. Flushing and cleaning of the test device must be made
as described in para. 5.2. After measuring is completed, the test device shell is stored in the suitcase. The high-pressure
regulator connection should be closed with the white protective cap. Function checks should be made every month, and
if erroneous measurements are suspected. It is advised to do a full-service check and recertify the BAT kit at a WatchGas
factory trained company every 12 months.
8.2 DISORDERS
If the handwheel of the test device cannot be loosened while it is connected to a compressed gas cylinder or compressor,
check if the connection is under pressure. In this case, close the cylinder valve or compressor valve and release air from the
test device.
•
Leaks at the connection to the cylinder or compressor could be due to a defect gasket. In this case, replace the gasket.
•
If the high-pressure regulator or the detector tube holder is defective, they must be replaced.
•
In case of other disorders the device should be returned for repair to WatchGas or any authorized service station.
9. Ordering & After Sales
PROVIDED BY:
WatchGas B.V.
Klaverbaan 121
2908 KD Capelle aan den IJssel
The Netherlands
+31 (0)85 01 87 709
info@watchgas.com
www.watchgas.com
D e t e c t i o n
All rights reserved. No part of this publication may be reproduced, distributed, or transmitted in any form or by any means, including
photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher, except in the
case of brief quotations embodied in critical reviews and certain other noncommercial uses permitted by copyright law. For permission
requests, contact WatchGas B.V.
WatchGas BAT-1, 2, 3 Breathing Air Quality Test Kit
Full Compliance with BS EN12021
DISTRIBUTED BY:
18
User Manual
V1.3
15-11-2021
Advertisement
Table of Contents
