Remove The Oven Door; Cabinet Installation - Electrolux E30EW85EPS Installation Instructions

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS

4. Remove the oven door

Remove the doors, oven grids and grids supports to reduce
the weight of the appliance and to facilitate its handling and
its installation. (Refer to the Use & Care Guide for the
instructions).
IMPORTANT
Do not lift the oven by the door handle.
NOTE: The oven door is very heavy. Be sure you have a firm
grip before lifting the oven door off the hinges. Use Caution
once the door is removed. Do not lay the door on its handle.
This could cause dents or scratches.

5. Cabinet Installation

Heavy Weight Hazard
• Use 2 or more people to move and install wall oven.
• Failure to follow this instructions can result in injury or
damage to the unit.
The wall oven can tip when the doors
are opened. The mounting brackets supplied with
the wall oven must be attached to the cabinet and
the appliance to prevent tipping of the wall oven
and injury to persons.
Mounting Brackets Installation Instructions
1.Unpack the wall oven and find the 2 mounting
brackets and screws included in the literature package.
2.Install the mounting bracket in the cabinet as shown on
figure 4. Note: To prevent damage to cabinet, it is
recommended to drill 1/16" (0.16 cm) dia. pilot holes
before installing the mounting brackets.
Cutout Dimensions
28 1/2" (72.4 cm) Min.*
29" (73.7 cm) Max.*
Mounting
Brackets
46"
(117.2 cm)
Figure 4
* Recommended
Cutout Width is 28½"
(72.4 cm)
51"
(129.5 cm) Min.
51 3/4"
(131.4 cm) Max.
3.Insert the unit into the cabinet opening. Slide unit inward
leaving 1 1/2" (3.8 cm) clearance between the oven and
front of cabinet (see Figure 5). Pull the armored cable
through the hole in the floor and toward the junction box
while moving the appliance inward.
4.Push the unit in and against the cabinet, then the oven
side bracket will clip in the one you just install on the side
of the cabinet opening (see figure 6).
Put back in place the grids supports, grids and oven
doors. (Refer to the Use & Care Guide for the
instructions).
To pull out the oven for servicing insert the tool supplied
with the appliance both side at the same time in the hole
located on the side frame and visible when the door is
opened. After inserting the tool pull the oven towards
you (see figure 7).
4
1 1/2" (3.8 cm)
clearance
between unit
and front of
cabinet
Figure 5
Figure 6