Remove The Oven Door - Electrolux E30EW85EPS4 Installation Instructions Manual

30" electric wall oven
Hide thumbs Also See for E30EW85EPS4:
Table of Contents

Advertisement

Available languages

Available languages

4. Remove
the oven
door
Remove the doors, oven grids and grids supports to reduce
the weight of the appliance and to facilitate its handling and
its installation. (Refer to tile Use & Care Guide for tile
instructions).
IMPORTANT
Do not lift the oven by the door handle.
NOTE: Tile oven door is very heavy. Be sure you have a firm
grip before lifting the oven door off the hinges. Use Caution
once tile door is removed. Do not lay the door on its handle.
This could cause dents or scratches.
5. Cabinet
JnstaNNation
Heavy
Weight
Hazard
Use 2 or more people to move and install
wall oven.
Failure to follow
this instructions can result in injury or
damage to the unit.
The walt oven can tip when the doors
are opened.
The mounting
brackets supplied
with
the wall oven must be attached
to the cabinet and
the appliance
to prevent
tipping
of the watt oven
and injury
to persons.
Mounting
Brackets installation
Instructions
1.Unpack the wall oven and find the 2 mounting
brackets and screws included in the literature package.
2. Install the mounting bracket in the cabinet as shown on
figure 4. Note: To prevent damage to cabinet, it is
recommended to drill I/16" (0.16 cm) dia. pilot holes
before installing the mounting brackets.
Cutout Dimensions
B
Mounting
Brackets
46"
(117,2 cm)
B
51"
B
_129,5 cm) Min,
51 3/4"
* Recommended
Cutout Width is 28_"
(72,4 cm)
Figure 4
3. Insert tile unit into the cabinet opening. Slide unit inward
leaving 1 I/2" (3.8 cm) clearance between the oven and
front of cabinet (see Figure 5). Pull the armored cable
through the hole in the floor and toward the junction box
while moving the appliance inward.
4.Push the unit in and against the cabinet, then the oven
side bracket will (:lip in the one you just install on the side
of the cabinet opening (see figure 6).
Put back in place tile grids supports, grids and oven
doors. (Refer to the Use & Care Guide for the
instructions).
To pull out the oven for servicing insert the tool supplied
with the appliance both side at the same time in tile hole
located on the side frame and visible when the door is
opened. After inserting the tool pull the oven towards
you (see figure 7).
1/2" (3,8 cm)
clearance
unit
and front
of
cabinet
Figure 5
Figure 6

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents