Table of Contents
Advertisement
Version: 2.5
Do not exceed the permissible axial forces
If the motor shaft cannot be inserted easily, the screw on the
clamping hub must be loosened a little more.
With certain motor shaft diameters, a slotted spacer sleeve must
be installed in addition. If there is a groove on the motor shaft, it
must be aligned with the slot in the spacer sleeve.
► Insert the motor shaft [1] into the clamping hub [2]
► Make sure that no gap is created between the motor and the
adapter plate
This example shows a motor size with four fixing points in the
flange.
► Coat screws [1], [2], [3] and [4] with threadlocker
► Insert bolts [1], [2], [3] and [4] and tighten evenly.
► Tighten bolt [5]. Refer to the chapter Clamping hub.
► Insert the screw plug back into the adapter plate
AG3300
Mechanical installation
───
55
Advertisement
Table of Contents
