Table of Contents
Advertisement
G2E140-AE77-01
3.2 Nominal data
Motor
M2E068-BF
Phase
1~
Nominal voltage / VAC
230
Frequency / Hz
50
Method of obtaining
fa
data
Valid for approval/
CE
standard
-1
Speed (rpm) / min
1400
Power consumption / W
105
Current draw / A
0.46
Capacitor / µF
2
Capacitor voltage / VDB
450
Min. back pressure / Pa
0
Min. ambient
-25
temperature / °C
Max. ambient
40
temperature / °C
Starting current / A
0.47
ml = Max. load · me = Max. efficiency · fa = Free air
cs = Customer specification · ce = Customer equipment
Subject to change
3.3 Technical description
Weight
2.61 kg
Size
140 mm
Motor size
68
Impeller material
Sheet steel, galvanized
Housing material
Die-cast aluminum
Direction of rotation
Clockwise, viewed toward rotor
Degree of protection
IP44; installation- and position-dependent
Insulation class
"B"
Moisture (F) /
H0 - dry environment
Environmental (H)
protection class
Installation position
Any
Condensation
None
drainage holes
Mode
S1
Motor bearing
Ball bearing
Touch current
< 0.75 mA
according to IEC
60990 (measuring
circuit Fig. 4, TN
system)
Motor protection
Thermal overload protector (TOP)
internally connected
Protection class
I (with customer connection of protective
earth)
Conformity with
EN 60335-1; CE
standards
Approval
CCC; EAC
Item no. 11113-5-9970 · ENU · Change 202174 · Approved 2018-12-28 · Page 5 / 11
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · info1@de.ebmpapst.com · www.ebmpapst.com
Operating instructions
1~
; Use the device in accordance with its degree of protection.
230
60
Information on surface quality
The surfaces of the products conform to the generally applicable industrial
ml
standard. The surface quality may change during the production period.
This has no effect on strength, dimensional stability and dimensional
CE
accuracy.
The color pigments in the paints used perceptibly react to UV light over
1500
the course of time. This does not however in any way affect the
115
technical properties of the products. The product is to be protected against
0.51
UV radiation to prevent the formation of patches and fading. Changes in
2
color are not a reason for complaint and are not covered by the warranty.
450
50
3.4 Mounting data
-25
Strength class of
screws
35
For screw clearance, see Chapter 3.1 Product drawing
0.48
; Secure the screws against unintentional loosening (e.g. use self-
Any further mounting data required can be taken from the product
drawing or Section Chapter 4.1 Mechanical connection.
3.5 Transport and storage conditions
Max. permitted
ambient temp. for
motor (transport/
storage)
Min. permitted
ambient temp. for
motor (transport/
storage)
With regard to cyclic speed loads, note that the rotating parts of
the device are designed for a maximum of one million load
cycles. If you have special questions, consult ebm-papst for
support.
8.8
locking screws).
+ 80 °C
- 40 °C
Advertisement
Table of Contents
