Table of Contents
Advertisement
en Cleaning and servicing
Turn on the tap.
1.
Insert the mains plug.
2.
Switch on the appliance.
3.
Pour 1 litre of water into the
4.
manual dosing compartment.
Start the
Drain programme.
5.
Cleaning the water outlet
hose at the siphon
If the water outlet hose at the siphon
is dirty or the detergent solution is
not being pumped out, you must
clean these.
Switch off the appliance.
1.
Disconnect the appliance's mains
2.
plug from the power supply.
Loosen the hose clamp and care-
3.
fully remove the water outlet hose.
Residual water may leak out.
Clean the water outlet hose and si-
4.
phon connecting piece.
52
Reattach the water outlet hose and
5.
secure the connection point using
the hose clamp.
Clean the water inlet filters.
Clean the filters in the water inlet in
the event of blockages or if the water
pressure is too low.
Emptying the water inlet hose
In order to be able to clean the filters,
you must first empty the water inlet
hose.
Turn off the tap.
1.
Set the Cottons
2.
Start the programme and leave it
3.
to run for approx. 70 seconds.
Switch off the appliance.
4.
Disconnect the appliance's mains
5.
plug from the power supply.
Cleaning the filter on the tap
Note: Please read the information in
the "Safety" → Page 4 and "Prevent-
ing material damage" → Page 11 sec-
tions to ensure that you use the appli-
ance safely.
Requirement: The water inlet hose is
empty.
Remove the water inlet hose from
1.
the tap.
programme.
Advertisement
Table of Contents
