Advertisement
13
Plate on motor
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
16
LED light
fixture
Connect white wire from fan to white wire
from LED light fixture and then connect
blue (or black) wire from fan to black (or
blue) wire from LED light fixture.
Attach LED light fixture onto the light pan,
aligning the keyhole slots on the LED light
fixture with the preassembled screws on
the light pan. Twist clockwise till lock.
Reinstall the screw removed in step 15.
Tighten all screws securely.
© 2018 Monte Carlo Fan Company
14
Light pan
Connect the quick connector from fan to
the quick connector from switch house
(light pan). Be sure they are clasped
together firmly.
Place light pan over the lead wires and
attach it onto the plate on motor, aligning
the keyhole slots on the light pan with the
preassembled screws on the plate. Twist
clockwise till lock.
Reinstall the screw removed in step 13.
Tighten all screws securely.
17
Glass
Attach glass by locating dimples in light
pan with grooves on the glass and twist
clockwise until tight.
5
15
Light pan
Loosen 2 and remove 1 preassembled
screw from light pan. Save screw for later
use.
18
Reverse switch
Setting the reverse switch in the left hand
side will result in downward airflow and
setting the switch in the right hand side
will result in upward airflow.
Note: Reverse switch must be set either
way completely. If the reverse switch is
set in the middle position, fan will not
operate.
02/2018
Advertisement
