Makita DUH483 Instruction Manual page 13

Adjust the hole positions by turning the gear as
illustrated.
1
► 1 . Grease
1
► 1 . Grease
Apply some grease provided with the new shear blades
as illustrated.
1
3
► 1 . Blade 2. Sponge 3. Sleeves
Put the removed sponge in the same position as the
old one. Make sure that the sleeves provided with the
new shear blades are put on the pins of the blade.
Place the new shear blades on the tool so that the pins
fit in the holes of the gear. If the sleeves on the pins
come off mistakenly, put them into the holes of the gear
beforehand.
1
► 1 . Screws 2. Washer
Install the blade and tighten the four screws and put the
removed washer in the same position as the old one.
► 1 . Screws
Install the under cover on the tool and tighten the four
screws firmly.
13 ENGLISH
2
1
2
1