About Suitable Specification Of Speaker; Connecting The Speakers - Pioneer GM-D8704 Owner's Manual

Connecting the units
Do not install or use this amplifier by wiring
speakers rated at 2 W (or lower) in parallel to
achieve a 1 W (or lower) bridged mode (Dia-
gram B).
Amplifier damage, smoke, and overheating
could result from improper bridging. The am-
plifier surface could also become hot to the
touch and minor burns could result.
To properly install or use a bridged mode and
achieve a 2 W load, wire two 4 W speakers in
parallel with Left + and Right * (Diagram A)
or use a single 2 W speaker.
In addition, refer to the speaker instruction
manual for information on the correct connec-
tion procedure.
For any further enquiries, contact your local
authorized Pioneer dealer or customer
service.
About suitable
specification of speaker
Ensure speakers conform to the following
standards, otherwise there is a risk of fire,
smoke or damage. Speaker impedance is 2 W
to 8 W, or 4 W to 8 W for two-channel and other
bridge connections.
Subwoofer
Speaker channel
Four-channel output
Two-channel output
Speaker output
A
Three-channel
output
Speaker output
B
Other than subwoofer
Speaker channel
Four-channel output
Two-channel output
Three-channel
output

Connecting the speakers

The speaker output mode can be four-channel,
three-channel (stereo and mono) or two-chan-
nel (stereo or mono). Connect the speaker
leads based on the mode and the figures
shown below.
Four-channel output
Power
Nominal input:
Min. 100 W
Nominal input:
Min. 300 W
Nominal input:
Min. 100 W
Nominal input:
Min. 300 W
1 Left
2 Right
3 Speaker output A
4 Speaker output B
En
Power
Max. input:
Min. 200 W
Max. input:
Min. 600 W
Speaker output Max. input:
A Min. 200 W
Speaker output Max. input:
B Min. 600 W
1
2
2
1
4
3