Table of Contents
Advertisement
7. Wheel lock assembly
These are used to hold the wheelchair in a stationary position, and are fitted on either side
of the wheelchair. They should not be used when the wheelchair is moving or to slow it
down. They should always be applied together.
To operate, push the brake lever forward towards the front of the wheelchair. This will
immobilize the wheelchair. To release the brake, move the lever towards the rear of the
wheelchair.
8. Cross Bar
Operation of the cross brace permits the wheelchair to be opened and closed easily. It
should be inspected at regular intervals for signs of wear and bending.
9. Folding Backrest Device
Push down the hinge to fold down the backrest. Automatically lock when pull up the
backrest handle. This device is to enhance the storage feature.
ROUTINE CHECKS AND MAINTENANCE
1. Upholstery
Upholstery should be routinely cleaned with a mild soap and water solution. Never use
paint remover or thinners on upholstery.
2. Metal Parts
Clean all metal parts with a wax compound such as car wash to maintain finish. Do not use
any obtrusive cleanser that will scratch the finish on the chair.
3. Cross Brace
Periodically lubricate the centre bolt on the cross brace with light machine oil.
4. Tyres and Wheels
Examine tyres regularly for wear and replace as necessary. Solid tyres should be replaced
when they become loose on the rim or cracks appear which expose the mounting wire
groove. For pneumatic tyres, check tyre pressure is even and correct. Check that the wheels
run freely and that quick release axles are correctly locked.
If your wheelchair is fitted with pneumatic tires and you have a puncture please take your
wheelchair to the nearest dealer or bicycle repair center
5. Castors
Check periodically that the bolt and nut securing the wheel to the castor fork is tight and
allows a snug but free spinning fit.
Continued on next page
Advertisement
Table of Contents
