Advertisement
20
20G
20 POP-UP ROD LINKAGE & ADJUSTMENT
Place one end of Spring Clip (20C) on end of Ball Rod (20B). Insert Ball Rod
(20B) across and through hole in Pop-Up Strap (20D). Secure other end of
Spring Clip (20C). Insert bottom of Lift Rod (20A) into hole at top of Pop-Up
Strap (20D). Tighten with Thumb Screw (20E).
using the Thumb Screw (20E) on the Strap (
20E) on the Strap (
20E
which Ball Rod (20B) goes through the Pop-Up Strap (20D). Be sure to leave
enough space between Lift Rod Knob (20F) and Spout Head (
Rod is down.
21
21 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below
the sink.
20F
20A
20A
20E
20C
20B
20D
20A
20A
20E
20D
20B
20C
20E).
20E Adjust Lift Rod (20A) height by
20D) or by adjusting the hole in
20F) and Spout Head (
20F
20G) when Lift
ENGLISH
MAINTENANCE & CARE
22
22A
22A
22 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (22A). Turn Valves
(22B) on and allow both hot and cold water to run for at least one minute each.
While water is running, check for leaks. To clean the aerator, disassemble Aerator
Housing (22A) by separating the Aerator Shell (22C), Basket (22D), and Washer
(22E). Once parts have been cleaned, reassemble by reversing steps.
22E). Once parts have been cleaned, reassemble by reversing steps.
22E
23
23 VALVE CARTRIDGE MAINTENANCE
Turn off water supplies and relieve pressure before working on your faucet (see
step 2). Remove Handles (see step 15), Valve Flange (23B) and Plastic Nut
(23C) (see step 13), unscrew Cartridge Assembly (23A) and inspect. Replace
parts as necessary.
6
22B
22E
22D
22C
23C
23B
23A
23A
Advertisement
