Advertisement
Thank you for purchasing this Price Pfi ster bathroom faucet. All Price Pfi ster products are carefully engineered, and factory tested to provide
long trouble-free use under normal conditions. This bathroom faucet is easy to install using basic tools and our easy to follow illustrated in-
structions. If you have any questions regarding your bathroom faucet installation call 1-800-Pfaucet (1-800-732-8238)
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding.
Price Pfi ster recommends calling a professional if you are uncertain about
installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are
usually found under the sink or near the water meter. If you are replacing an
existing faucet, remove the faucet from the sink and clean the sink surface
thoroughly.
3
3 TOOLS RECOMMENDED
• PTFE plumber's tape or thread sealant
• Slotted screwdriver
• Phillips head screwdriver
• Adjustable wrench
• Flashlight
Your installation may require new supply lines and/or shut-off valves or other
additional tools.
This product comes with an installation tool used for securing the spout, and valve body
assemblies, as well as a hex wrench for tightening a set screw into the handle.
INSTALLATION STEPS
4
4C
4 SPOUT ATTACHMENT
Place the round Seal (4A) against the bottom of Spout Body (4B). Insert Spout
Shank (4C) through the center hole of sink.
ENGLISH
• Plumber's putty
• Pliers
• Cloth
4B
4A
2
5
5E
5B
5C
5 SPOUT INSTALLATION
Insert Lift Rod (5D) into hole at the back of Spout (5E). From underneath sink,
place Mounting Washer (5A) onto Spout Shank (5B) and hand tighten with
Mounting Nut (5C). Align Lift Rod (5D) with slot in Mounting Washer (5A).
6
6A
6D
6C
6 SECURING SPOUT
From underneath, tighten Mounting Nut (6A) by using Installation Tool (6B).
Before fi nal tightening, be sure Spout (6E) is centered and facing forward. For
better leverage, use a Screwdriver (6C), insert it through Hole (6D) and tighten
the Mounting Nut (6A) until Spout (6E) is fi rmly secured to sink.
.
5D
5A
5E
5E). From underneath sink,
6E
6B
6E
6A
6E) is centered and facing forward. For
6E
6E) is fi rmly secured to sink.
6E
Advertisement
