Signtex CAE Series Installation Instructions And Owner's Manual

Crystal
Designed to meet requirements of State of Connecticut,
State Fire Safety Code Para 1011.1.1 and 1011.1.2
INSTALLATION INSTRUCTIONS AND OWNER'S MANUAL
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
Before connecting to power supply, TURN OFF ELECTRICAL
Consult your local building code for approved wiring and installation.
Mount and secure exit sign at a location and height to avoid
Accessible Exit

IMPORTANT SAFEGUARDS

POWER AT CIRCUIT BREAKER OR FUSE
Disconnect AC power before servicing.
Refer to wiring diagram for proper connections.
All servicing should be performed by qualified personnel.
Do not use outdoors.
Suitable for indoor damp locations (when specified).
Do not let power cords touch hot surfaces.
Do not mount near gas or electric heaters.
ready access and tampering by unauthorized persons.
(Exception: Floor proximity installations)
The use of accessory equipment is not recommended by
the manufacturer and may cause an unsafe condition.
Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS
Signtex Inc
S P E C I F I E D S P E C I F I E D
LIGHTING
E M E R G E N C Y E M E R G E N C Y L I G H T I N G L I G H T I N G
Edge- lit LED
Sign System
Series CAE
REV 01.12.02